Sequential shift light1/26/2024 I was wondering if anyone has any ideas about the code and if they can see any glaring errors at all? Maybe the board isn't picking up revs correctly?Īnyway, here it is and thanks in advance. I get a response from the Arduino and can upload the code, but the shift lights don't seem to be coming on when I rev the car. Not shown on the diagram, but I'm using 1k ohm (I think) resistors with each LED. The circuit diagram is below, as is the code I'm using. In daily drive, It helps to reduce fuel consumption. In high performance or track use, It helps to shift at an rpm where your car has the optimal point for the next gear. The project I'm working on is for a set of sequential shift lights for my car that come on one by one as the revs (rpm) rises. HTM Shiftlight’s Benefits (EN) Indicating optimal shifting points without looking at the rev counter. Estimated Ship Date: Would you rather pick it up Select Location. Shift Light Module, Sequential, LED, 5-Stage, Each. Used to extend to CAN devices when necessary.Have been working through this for a while now and am still finding some issues, so I was hoping a post might be able to shed some light on the problems I've been having. Stack Sequential Shift Light Modules ST539. There is a way to enable it that requires jumping 2 circuit board pads, but we recommend using the inline terminator instead. The ShiftX3 does NOT ship with an internal CAN terminator enabled. Required to terminate CAN 2 bus chains if your equipment does not have a built-in terminator.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |